MRT (MINITROL)
Low Cost, Pulse Input Totalizer/Ratemeter
Process Valve & Equipment Co.
Distributor For:
KESSLER ELLIS IS A MANUFACTURER OF COUNTERS, TIMERS,
BATCHERS FOR MOST ALL PROCESS APPLICATIONS. BELOW
ARE TWO OF OUR FAVORITE PANEL METERS:
MRT (MINITROL) |
|
PROCESS VALVE & EQUIPMENT CO.
PROMOTES
KESSLER ELLIS PANEL METERS FOR USE ON
ALL OF OUR POSITIVE DISPLACEMENT FLOW
METERS, FOR REMOTE RATE/TOTALIZATION
WITH OR WITHOUT ADDITIONAL OUTPUTS TO A
PLC OR RECORDER ETC.. THIS ONES THE TICKET!
Features |
Description |
|
The MINITROL is a 6 digit totalizer / ratemeter with two level, 5 digit preset alarm control of total or rate. Inputs A & B have separate scaling K-factors. The totalizer can be programmed for “A” subtract “B”, “A” add “B” or A & B as separate totalizers, with display and control of the “net” total and rate of "A". The MINITROL is also available in 4 other versions. MC2: a two preset totalizer with scaling, MR2: a high/low alarm ratemeter with scaling; The “MC”: a totalizing counter only, and the “MR”: a rate meter display only. If only one input is required, the unit will display the total and rate from that one channel. The MINITROL can accept up to 10,000 pulses per second. It has a 5 digit floating decimal scale factor allowing total readout in true engineering units and rate per second, minute or hour. Input “A” simultaneously drives a ratemeter which can be programmed to display the basic frequency (rate per second) or factored to show rate per minute or rate per hour. Simply push the “VIEW” button to see either total or rate without losing a count. Two separate 5 A relay contacts can be set to operate at either rate or total presets in a latch or auto-recycle mode with output timing from 0.1 to 99.9 seconds. Two control outputs can be assigned to either the totalizer or ratemeter and can automatically recycle at the batch or stay latched until reset. Up to 99 units can communicate to a host computer on a single RS232 or RS422 loop. When two inputs are received (A & B), the unit can either add or subtract the two inputs or display the two inputs as separate totalizers. |
MASStrol |
 |
Features |
Description |
|
The KEP MASStrol is a microprocessor based instrument designed to measure compensated flow in an industrial environment. Three analog inputs for temperature, pressure and flow are provided to measure the parameters needed to calculate the actual compensated mass, volume or heat flow. Special signal conditioning circuitry is included to allow direct connection of platinum resistance temperature detectors (RTD’S). A high speed digital input is provided to interface with pulse output type flowmeters. As an alternative, voltage inputs or current loops can be used for the above. All instrument interface is with a 32 point screw terminal strip on the rear of the instrument. |
CONTACT: PROCESS VALVE & EQUIPMENT
APPLICATION ASSISTANCE
1-440-247-6111 OR
1-800-922-8897 TOLL FREE
| Kessler-Ellis Products |  |
